| |
|
AT-10 |
|
|
1x2
Ground Loop Blocking,
Active Transmitter, UTP / CAT-5 |
|
FEATURES:
ˇOne UTP & One
Coax Output
ˇOne UTP / One
Coax Input
ˇGround Loop
Blocking Input
ˇPassive or
active receivers
ˇHigh quality
Color video performance
ˇVariable gain
control
ˇUL listed Power
Supply
ˇMade In The USA
|
|
|
 |
 |
 |
 |
 |
|
|
The AT-10 is a
Coax / UTP input, ground loop blocking, high
performance active transmitter with one UTP and one
Coax output. The AT-10 has a gain adjust to
compensate for signal level loss. The differential
input amplifier is used to minimize or eliminate
ground loop problems. The active UTP output can
drive either active or passive receivers. This board
is designed to tap off of an existing UTP system
with a Coax feed for a DVR or monitor with BNC
inputs.
|
|
|
SPECIFICATIONS |
|
|
VIDEO |
|
Input(1): |
Coax or UTP / CAT-5 |
|
Input Connectors: |
BNC |
|
Input Level: |
1vpp |
|
Input Impedance: |
75 ohm +/-5% (Coax) |
|
|
100 ohms (UTP / CAT-5)
|
|
Output(2): |
1 Coax & 1 UTP / CAT-5 |
|
Output Connector: |
1
BNC (Coax) & 1 Terminal Strip (UTP / CAT-5) |
|
Output Impedance: |
75 ohms +/-5% (Coax) |
|
|
50 ohms +/-5% (UTP / CAT-5)
|
|
Gain In / Out |
+/-3dB |
|
Diff Gain: |
<1% |
|
Diff Phase: |
<1° |
|
Frequency Response: |
0-15mHz +/- .5dB |
|
Power / Supply Hum: |
<63dB |
|
H Tilt: |
<1% |
|
V Tilt: |
<1% |
|
CCMR: |
Type. 60dB @ 4Mhz |
|
High Freq. Boost: |
Type 0+/- 10dB |
|
POWER
REQUIREMENTS |
|
DC Operation: |
12 to 18 VDC Isolated Source |
|
AC Power Draw: |
Depends On Card Installed In Unit |
|
Power Connector: |
3.5mm Phono |
|
MECHANICAL |
|
Size: |
5.50"W x 6.25"D x 1.6"H |
|
Weight: |
1 lbs |
All
Specifications Are Subject To Change Without
Prior Notification
|
|
| |
